اتصال زن بیسکویتی

http://wwwcdn.popularwoodworking.com/wp-content/uploads/3-mrk_dpth-300x200.jpg

Adjust the depth setting on the tool so the gap between the two lines is about 1⁄8". This will allow some room for glue within the joint and some lateral movement for fitting.

Don’t worry about centering the slot on the thickness of the material. Set the fence so that the slots will register from the base of the tool.

The most common mistake is allowing the machine to tilt as you cut the slot, preventing the parts from lining up properly.

Don’t worry about centering the slot on the thickness of the material. Set the fence so that the slots will register from the base of the tool.

Problems arise if you don’t hold the work steady and you don’t keep the tool flat. This simple jig will let you keep both hands on the tool and the workpiece from moving.

A guide block will locate the position of a shelf, and provide layout marks.

Don’t waste your time measuring and marking the exact locations of the plates. Hold the parts together and make your marks by eye.With both hands on the tool, you have more control. When you place the tool on the work, push down with the hand on the handle before pushing in with the hand on the barrel.

To keep from tilting the machine when making a vertical cut, extend your pencil marks so you’re lining up with the center mark on the base, not on the fence.

Lock your arms in position before turning on the machine. Make the cut by shifting your weight with your legs, not by pushing with your arms. This will keep you from tilting the machine as you make the cut.

The joining plates are usually compressed  by machine when they are made, and swell up as water from the yellow or white glue enters the biscuit. This is a dry plate.

Practice getting the right amount of glue in the slot. You want to coat the surface of the plate without having excessive glue squeeze-out, or introducing too much moisture in the interior of the joint.

3-sizes

مطلب مفیدی برای شما بود ؟ پس به اشتراک بگذارید برای دوستانتان

عباس جمالی

281 مطلب منتشر شده

کارشناس و متخصص صنعت چوب و مبلمان/نویسنده و مدرس رشته طراحی و تولید مبلمان

درباره این مطلب نظر دهید !

ثبت نام کلاس‌های حضوری آموزشگاه